Montreal wrote: Jan 10, 2025 5:12 PM A few questions regarding your superb Alpina B7 Turbo/1
1) Is there a BOV from the factory in the installation ?
2) Regarding the hood latches ( female parts), did you paint them, since they are galvanized parts from factory I think ? Or you had them re-dipped in zinc ?
3) Was the car dynoed ? Results ? Can you post graph ?
4) What is the engine oil temp reading on the Alpina digital gauge when at operating temperature ?
5) What type of gear oil do you prefer for the Getrag 265 ?
6) Can you explain the functioning of the Ladedruck ( boost control ) knob between the seats ?
Thank you!
Sorry for the delayed reply Montreal, I haven’t been on the forum in a while.
1. No blow off valve from me or the factory, just a waste gate.
2. I zinc coated the latches then dipped in clear/light blue chromate. Not stock but I like the look and it’s very subtle and won’t rust.
3. Not dynoed.
4. From memory, I believe it reads 85C at temp. Next time I drive it I’ll check and correct if this is wrong.
5. I use ATF.
6. It’s been a while since I’ve had the boost apparatus apart but it regulates the air pressure to either side of the diaphragm in the waste gate and thereby regulating turbo boost.
1. No blow off valve from me or the factory, just a waste gate.
2. I zinc coated the latches then dipped in clear/light blue chromate. Not stock but I like the look and it’s very subtle and won’t rust.
3. Not dynoed.
4. From memory, I believe it reads 85C at temp. Next time I drive it I’ll check and correct if this is wrong.
5. I use ATF.
6. It’s been a while since I’ve had the boost apparatus apart but it regulates the air pressure to either side of the diaphragm in the waste gate and thereby regulating turbo boost.