Shadow wrote:I hear he is done and tired with the old bmw sohc engines
and bought a e36 m50 to turbocharge.
I did pick up an E36, but just to make manifolds. And I will never give up on the M30.
As for updates, haven't had time to mess with it. I did take it to the 1/8 mile a few months ago but never got a full pass.
It ran a 8.4 at 60mph, basically 1st and 2nd then letting off coasting through the lights, car still swaying all over.
Twisted the driveshaft and blew the guibo apart after a 6k launch that night.
Swapped the 3.73lsd to a welded 2.93 also.
What kind of boost are you running now? So, since you went through the original headgasket on the stock motor, you haven't opened it up again?
Seems very reliable for what it goes through you done an excellent job in tuning and building this car. I Dont understand why there isnt more praise for this video. I posted your video on our local BMW site, and it got alot of jaw drops. Great work, is an understatement, but its all i got for now
shocka wrote:What kind of boost are you running now? So, since you went through the original headgasket on the stock motor, you haven't opened it up again?
Seems very reliable for what it goes through you done an excellent job in tuning and building this car. I Dont understand why there isnt more praise for this video. I posted your video on our local BMW site, and it got alot of jaw drops. Great work, is an understatement, but its all i got for now
That was around 18psi, I turned it down after the dyno. Haven't opened up after installing the MLS. I beat the heck out of the engine and it's still going.
Ordered a 10 point cage this week, I don't want to get kicked out on the first pass.
cvillebimmer wrote:Wheel spin to nearly 100mph ! That's sick, Otis. Nice meeting you at Vintage, wish I had a little more time there.
Likewise Andrew nice meeting also, it was a great event.
Hey guys it's been awhile since there was an update. Car has been under the knife with a 10point roll cage and fuel cell. Also a Paul Burke C4 transmission in the works.
Made Jan issue of Performance BMW.
Here are the pics. The gave me the centerfold section. Haha this is funny.
I gave a plug for MyE28.com. Thanks for all your support guys.
3.73final drive in my opinion is the best ratio for 1/4mile run if you are using a 26inx8 or 10 in. mickey thompson slics..and at your current whp..10s sec timeslip doable...and 130mph trap speed.regarding the 2.93final drive...too tall..you will be crossing the 1/4mile in 3rd gear.this is if you are using a getrag 260/6 or 265.
Thanks, I'm running 94 octane with about 15% ethanol which is the best I can get here and on 79 lb/hr hi-z injectors. I have no idea where that will lead me but I'm also running the snow water/meth kit. Bought the tool to oring the block and arp's from Todd. I have no idea the safe limit for this setup so we'll see
Edit: all I know I'd I managed to get it to rev past 2000 today in the garage and I think my ears are bleeding. 4" downpipe to nothing right now. I'm just glad my truck is parked behind it so I don't get tempted to do something stupid.
Just got back from the track, and had great time. Made about a dozen passes. Track rental is the way to go, no lines and no 1 or 2 hour wait times to run.
Met up with Bigmac834 he's took some video of the runs. All in all had a great time, plus being the oldest car there with one of the highest trap speed made it even better.
All the runs were pretty consistent trap speed wise, here's the best pass.
Boost was around 20-22.