Page 1 of 1
Need M20 ETA flywheel
Posted: Jan 11, 2025 4:53 PM
by Notelect
Flywheel I got is missing metal tab for reference sensor.
Tab looks as such image below
Need either of these part numbers
11221273153
11221705046
Need it before the 27th ideally
Can pay $300 now
Re: Need M20 ETA flywheel
Posted: Jan 12, 2025 4:25 PM
by G28I
Being unfamiliar with the cross overs, would you be able to use an m30 flywheel? I am aware the clutch pressure plate and disc would need to correspond with the selected flywheel. If so, I do have an M30 flywheel available.
Re: Need M20 ETA flywheel
Posted: Jan 12, 2025 4:28 PM
by Bimmerguy2002
G28I wrote: Jan 12, 2025 4:25 PM
Being unfamiliar with the cross overs, would you be able to use an m30 flywheel? I am aware the clutch pressure plate and disc would need to correspond with the selected flywheel. If so, I do have an M30 flywheel available.
the teeth are incompatible
I think i have a euro 323i flywheel and clutch kit still, will be able to look shortly. It is 13 lbs and has the same stack height as the dual mass with the pressure plate.
Re: Need M20 ETA flywheel
Posted: Jan 13, 2025 5:35 PM
by Bimmerguy2002
if you are still looking, i did have it, its a euro 323i flywheel, single mass with reference pin, sachs friction disc and pressure plate. 450 shipped. It has the same stack height as the dual mass and is just a lighter 325i flywheel but with a reference pin. Just need the 325i throwout bearing.
https://ibb.co/8x7d63W
https://ibb.co/r77z4x4
https://ibb.co/KxwGsQz
Re: Need M20 ETA flywheel
Posted: Jan 14, 2025 6:57 PM
by Notelect
Bimmerguy2002 wrote: Jan 13, 2025 5:35 PM
if you are still looking, i did have it, its a euro 323i flywheel, single mass with reference pin, sachs friction disc and pressure plate. 450 shipped. It has the same stack height as the dual mass and is just a lighter 325i flywheel but with a reference pin. Just need the 325i throwout bearing.
https://ibb.co/8x7d63W
https://ibb.co/r77z4x4
https://ibb.co/KxwGsQz
Does this work with an eta m20?
Re: Need M20 ETA flywheel
Posted: Jan 14, 2025 7:23 PM
by Bimmerguy2002
Notelect wrote: Jan 14, 2025 6:57 PM
Bimmerguy2002 wrote: Jan 13, 2025 5:35 PM
if you are still looking, i did have it, its a euro 323i flywheel, single mass with reference pin, sachs friction disc and pressure plate. 450 shipped. It has the same stack height as the dual mass and is just a lighter 325i flywheel but with a reference pin. Just need the 325i throwout bearing.
https://ibb.co/8x7d63W
https://ibb.co/r77z4x4
https://ibb.co/KxwGsQz
Does this work with an eta m20?
absolutely, the car it was from is an m20 (e30 323i), its just lighter significantly. The same stack height as your assembly as long as you use the corresponding clutch disc and pressure plate as the dual mass one you have has a thinner pressure plate